Billion Electric Company BiPAC 7402VL User Manual download pdf (Page 48)

VoIP/(802.11g) ADSL2+ Router

Chapter 4: Configuration

Authentication Protocol: Default is Chap(Auto). Your ISP will advise you whether to use Chap

or Pap.

Connection:

 Always on: If you want the router to establish a PPPoE session when starting up and to

automatically re-establish the PPPoE session when disconnected by the ISP.

 Connect to Demand: If you want to establish a PPPoE session only when there is a

packet requesting access to the Internet (i.e. when a program on your computer attempts to

access the Internet).

Idle Timeout: Auto-disconnect the broadband firewall gateway when there is no activity on the line

for a predetermined period of time.

 Detail: You can define the destination port and packet type (TCP/UDP) without checking by

timer. It allows you to set which outgoing traffic will not trigger and reset the idle timer.

RIP: RIP v1, RIP v2, and RIP v2 Multicast. Check to enable RIP function.

MTU: Maximum Transmission Unit. The size of the largest datagram (excluding media-specific

headers) that IP will attempt to send through the interface.

Advanced Options (PPPoE)

LLC Header: Selects encapsulation mode, true for using LLC or false for using VC-Mux.

Create Route: This setting specifies whether a route is added to the system after IPCP (Internet

Protocol Control Protocol) negotiation is completed. If set to enabled, a route will be created which

directs packets to the remote end of the PPP link.

Specific Route: Specifies whether the route created when a PPP link comes up is a specific or

default route. If set to enabled, the route created will only apply to packets for the subnet at the

remote end of the PPP link. The address of this subnet is obtained during IPCP negotiation.

Subnet Mask: sets the subnet mask used for the local IP interface connected to the PPP transport.

If the value 0.0.0.0 is supplied, the netmask will be calculated from the class of the IP address

obtained during IPCP negotiation.

Route Mask: Sets the subnet mask used by the route that is created when a PPP link comes up. If

it is set to 0.0.0.0, the subnet mask is determined by the IP address of the remote end of the link.

The class of the IP address is obtained during IPCP (Internet Protocol Control Protocol)

negotiation.

MRU: Maximum Receive Unit. This is negotiated during the LCP protocol stage.

Discover Primary / Secondary DNS: This setting enables/disables whether the

primary/secondary DNS server address is requested from a remote PPP peer using IPCP. The

default setting for this command is enabled.

Give DNS to Relay: Controls whether the PPP Internet Protocol Control Protocol (IPCP) can

request the DNS server IP address for a remote PPP peer. Once IPCP has discovered the DNS

server IP address, it automatically gives the address to the local DNS relay so that a connection

can be established.

Give DNS to Client: Controls whether the PPP Internet Protocol Control Protocol (IPCP) can

request a DNS server IP address for a remote PPP peer. Once IPCP has discovered the DNS

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 119 120

No comments

Billion Electric Company BiPAC 7402VL User Manual Page 48